Every shift

A tray wrapper in a fresh counter works in a wet, cold, busy environment. Most of what goes wrong is maintenance, not failure, and almost all of it can be done by the operator.

Every shift: clean the film path. Film dust and food residue build up on the rollers and cause uneven stretch. Wipe with a dry cloth, and check that the film roll is sitting square.

Every shift: check the tray support and the sealing area. Food debris under a tray changes the wrap height. A clean support gives a repeatable pack.

Daily: look at the film roll. A roll that is nearly finished should be changed before the peak, not during it.

Weekly and monthly

Weekly: check the film tension setting against a test pack that has been in the chiller for an hour. Warm packs look tight and cold packs do not, so test cold.

Weekly: inspect the blade or cutting edge. A dull edge leaves a ragged film tail, which then catches on the next pack.

Monthly: check the guide rails and any wear parts named in the manual. Replace what is worn rather than waiting for a jam.

Monthly: confirm the machine is level and that the feet are still in contact with the floor. A machine that rocks produces inconsistent packs, and staff compensate by hand without telling anyone.

Two habits that make it easier

Once a year: have the machine checked against its original settings, and replace the wear parts as a set rather than one by one.

Two habits that make all of this easier. Keep a simple log by the machine with the date and what was done; a log that is too detailed does not get filled in. And photograph the film path on day one, while it is clean, so anyone can see what it should look like.

We supply the machines and the wear parts, and can send a one-page maintenance sheet in your language for the counter. Ask for it when you place the order.