Why film bundling fits harnesses
Cable harness plants tie bundles with tape, bands or wire. It works, it is cheap, and it depends entirely on how many people can be assigned to the task that day.
A film bundling machine does the same job differently. The operator places the bundle in the machine's mouth, the film wraps around it and closes, and the bundle comes out in about two seconds. Rated output is around 1,800 bundles per hour, which is faster than hand tying and does not tire.
The same machine that bundles leafy vegetables bundles harnesses because both are long, flexible objects that need holding together. What changes is the bundle diameter, which has to sit inside the machine's range of 30 to 145 mm, and the bundle length, which has to clear the machine's mouth.
What to check before using one
What to check before using one on harnesses:
Bundle diameter range. Measure your smallest and largest bundle, including the connectors if they are inside the wrap. A bundle with a connector at one end can exceed the diameter range even when the wires do not.
Film. The machine runs dedicated 30 mm PE film. On harnesses, the wrap holds the bundle without adhesive residue, which matters if the bundle goes into a panel where tape residue is unwelcome.
What plants report
Speed and handling. A machine rate only helps if the bundle is presented consistently. In practice, plants use a simple jig or a marked position on the bench so the operator places each bundle the same way.
Consumable cost. Film per bundle is generally higher than tape per bundle. On high volume the labour saving usually covers it, but the calculation should be done with your own numbers.
One harness plant in Beijing replaced hand tying with six film bundling machines in 2025 and reports roughly three times the output at the same headcount, in the customer's own assessment.
Send us a sample bundle with its diameter and length, and we will confirm whether the standard machine fits or a jig is needed.
