Check the bag mouth first

A clipping machine jams when the clip cannot close around the bag mouth. The machine is usually the last part of that chain to fail, which is why replacing parts rarely fixes it.

Check the bag mouth first. A bag that is twisted, folded double or still holding air will not sit flat in the clipping position. Teach the operator to flatten the bag neck and pull it straight before presenting it. In most plants we visit, this alone removes half the jams.

Check bag material and thickness. Thin bags slip; very thick or laminated bags resist the forming head. If a new bag supply started the problem, test the old bag alongside the new one on the same machine and settings.

Material, feed and forming head

Check clip or nail feed. Open the cover and look at the track. A single deformed clip stops the feed, and the machine then cycles dry. Clear the track, then run ten test bags while watching whether the clips advance evenly.

Check the forming head. Residue from bags, film or dust builds up on the forming surfaces and changes the closing geometry. Clean it with a dry cloth at the end of each shift, not once a week.

Two settings that help on marginal bags: the anti-pinch area position, and the clip depth. Change one at a time and run ten bags between changes, otherwise you cannot tell which change worked.

When to call for service

If the machine cycles without closing and the bag is flat and the track is clear, record a ten second video of the failure. The timing of the cycle tells a technician whether it is the sensor or the drive, and saves a visit.

We supply 711 and 712 clipping machines and their dedicated nails, and can advise on bag specification. Send a sample bag and we will tell you whether it suits the machine you have.